Safety and handling
Our thinner, turpentine, french polish and retarder are flammable liquids. Most incidents in this trade come from vapour, not from the liquid itself. This page covers the basics; the safety data sheet is the document that governs. Masking tape is not covered here.
At a glance
Confirm the exact figures for the product you hold against its safety data sheet, since they differ from product to product.
| Property | Typical |
|---|---|
| Transport class | Class 3, flammable liquid |
| UN number | UN 1263 |
| Flash point | See the safety data sheet |
| Vapour density | Heavier than air |
| Storage temperature | Below 30 °C, out of sunlight |
Storage
- Keep stock in a ventilated, shaded store, away from boilers, welding bays, grinders and switchgear.
- Keep containers closed. An open drum fills the room with vapour long before you can smell a problem.
- Bund the storage area so a leaking drum cannot reach a drain or a watercourse.
- Store away from oxidising agents, acids and compressed gas cylinders.
- Rotate stock. Use the oldest batch first and keep the batch number visible on the pack.
Handling and decanting
- Earth and bond the drum and the receiving container before you decant. Static from free-falling solvent is a real ignition source.
- Use a hand pump or a tap, not a hammer and a screwdriver.
- No smoking, no open flame, no hot work anywhere near the decanting point.
- Work with doors open or under extraction, so vapour does not collect at floor level.
- Never use thinner to wash your hands or clean your skin.
Personal protection
- Solvent-resistant gloves, checked for splits before each use.
- Goggles or a face shield when decanting or spraying.
- A respirator with an organic vapour cartridge for spray application, not a dust mask.
- Cotton overalls and closed footwear. Change clothing that has been soaked.
If someone is exposed
Eyes: rinse with clean running water for at least 15 minutes, holding the eyelids open. Skin: wash with soap and water. Breathing in vapour: move the person to fresh air. Swallowed: do not make the person vomit. In every case, get medical help and take the safety data sheet with you.
Spills
- Cut off ignition sources first, then ventilate the area.
- Contain the spill and absorb it with sand, earth or a proper absorbent. Do not use sawdust.
- Collect the absorbent into a closed, labelled container for licensed disposal.
- Do not wash solvent into a drain, a canal or the ground.
Fire
- Use dry chemical powder, carbon dioxide or alcohol-resistant foam.
- Do not aim a water jet at burning solvent. It spreads the fire.
- Water spray can be used to cool drums that are exposed to heat, from a safe distance and upwind.
- Keep the right extinguishers within reach of the store and the decanting point, and have them serviced.
Transport and disposal
Move stock in closed, labelled, undamaged packs, secured so they cannot tip or chafe. Waste thinner and contaminated absorbent go to a licensed collector. Empty drums still hold vapour and are still a fire risk, so keep the bungs in until they are handed over.
Safety data sheets
We issue a safety data sheet for every liquid product. Ask for the current version by product name and we will send it by email, usually the same day. Keep a copy where the material is stored, not in an office drawer.
This page is general guidance for people already trained to work with flammable liquids. It does not replace the safety data sheet, your own risk assessment, or the requirements of the authorities that licence your site.